Caldigit HDPro Rackmount Kit Instrukcja Użytkownika

Getting Started HDPro RackMount Kit Installation Guide

21. 1 x HDPro Rackmount UPPER / LEFT Kit AND 5 x Type-I screws. 2. 1 x HDPro Rackmount LOWER / RIGHT Kit AND 10 x Type-II screws3. 5 x Rackmount Rack

3Please follow these installation steps:1. Place the HDPro on a table or a smooth surface area.2. Using a Phillips “crosshead” screwdriver, please uns

43. The top handle bar module will be replaced with the HDPro Rackmount UPPER / LEFT Kit AND Type-I screws.4. Insert the HDPro Rackmount UPPER / L

55. Using a Phillips “crosshead” screwdriver, please unscrew the six screws from the HDPro chassis (shown in the following picture), and then

67. Using the HDPro Rackmount LOWER / RIGHT Kit to cover the HDPro chassis, and then secure the kit with 6 Type-II screws.8. Place the HDPro Fron

79. Open the HDPro's rear gate, then place the HDPro Internal Disk label along the right side of the internal wall. (See the following pictu

811. Using the Rackmount Rack Rail Mounting screws, you can now mount the HDPro on to the Rack rails. CalDigit HDPRo RackMount Kit Installatio